Your board. Ready to go.
Install firmware on a new board, or connect to an existing nucula to configure Wi-Fi and use its console.
Connect to nucula
DisconnectedRequires nucula firmware already installed on the board. Connect over USB to configure Wi-Fi or use the serial console. For a new or unflashed board, use Initial firmware install / update.
Use a USB-C data cable and select USB JTAG/serial debug unit or the Espressif port when prompted.
Initial firmware install / update
Flash nucula onto a new board or update an existing installation. This works even when no firmware is installed. Plug in the USB cable and start here; the installer will ask you to select the board.
Loading the available firmware…
If the USB port won’t stay available, hold BOOT, tap RESET, then release BOOT before starting the installation.
Connect to Wi-Fi
Choose a 2.4 GHz network. Your credentials go directly to the board over USB and are saved there for the next startup.
Requires installed nucula firmware. Connect to nucula above to configure Wi-Fi.
Serial consoleAdvanced · 115200 baud
Requires installed nucula firmware and a USB connection. Commands can move funds or change wallet data. Use help to see the available commands.
Connect your board to see its serial output.